Mines run on water control and slurry. Trident builds the submersible motors behind it: mine dewatering, slurry and tailings transport, and deep sea sand mining, in water that is abrasive, chemically loaded or both. Every motor is built to specification around your pumps and installation, delivered with cables pre-mounted, typically in 12 to 16 weeks.
Deep, dirty and often chemically loaded water, pumped around the clock. TKBS motors run fully submerged at IP68, with materials and seals selected for the water composition, stand-still heating and full sensor monitoring for unmanned duty.
High-density abrasive mixtures ask for low-speed, high-torque drives. The TKBS platform runs up to 24-pole, on VFD across a wide speed range, with wear-resistant sealing configurations for continuous slurry service.
Salt and abrasive combined, down to 300 m with Type II pressure compensation. The same platform that drives Trident's dredge pump and cutter motors, configured for mining duty.
One to one from a nameplate or drawing: foundation, shaft end and connection dimensions stay exactly as they are. Built to spec in 12 to 16 weeks, cables pre-mounted and factory-tested.
TKBS motors handle nearly all chemical soil compositions: salt, brackish and contaminated water, sulphide-rich and aggressive process media. Materials and sealing are chosen per project.
Nearly all chemical soil and water compositions: salt, brackish, contaminated, sulphide-rich process water.
Shell materials up to stainless and duplex options; the seal configuration is selected for the medium it runs in.
Winding and bearing temperature, moisture per chamber and leakage detection, routed to your protection system.
Built to spec with the committed date in the commercial offer. Cables pre-mounted, glands sealed and tested in the factory.
A photograph of the existing motor plate is enough to begin. Trident engineering responds with a TKBS retrofit configuration and a delivery commitment.